theguy1084
Ready to race!
- Location
- Charleston, SC
I have a Pagparts turbo kit that I was going to install this month. Things have happened in my life where I need to look into selling it. It is all new never installed. I paid $7000 for everything. Ill ship it to you for $6800.
ss vbanded manifold
PTE 5530R billet .63ar ss vbanded
oil feed line kit
GT restrictor
coolant line kit
clamp mani/turbo
3” SS DP w/ long test pipe to catback (should meet up w/ your catback as its very long)
inlet piping set
Tial MVS WG 1 bar
Dump rerouted
RS4 injector set
Eurodyne Maestro w/ Mafless base file
charge piping set
FMIC
Brute Rods
9.5:1 low compression head gasket
Rod Bearings
ARP head studs
Gasket set
Also a tial BOV that I was going to use instead of the DV
I think that is all. I am not going to part it out because if it doesnt sell I may still use it at some point. If you have any question just ask.
Here is a link to a build thread I started.
http://golfmkv.com/forums/showthread.php?t=157013
ss vbanded manifold
PTE 5530R billet .63ar ss vbanded
oil feed line kit
GT restrictor
coolant line kit
clamp mani/turbo
3” SS DP w/ long test pipe to catback (should meet up w/ your catback as its very long)
inlet piping set
Tial MVS WG 1 bar
Dump rerouted
RS4 injector set
Eurodyne Maestro w/ Mafless base file
charge piping set
FMIC
Brute Rods
9.5:1 low compression head gasket
Rod Bearings
ARP head studs
Gasket set
Also a tial BOV that I was going to use instead of the DV
I think that is all. I am not going to part it out because if it doesnt sell I may still use it at some point. If you have any question just ask.
Here is a link to a build thread I started.
http://golfmkv.com/forums/showthread.php?t=157013