Interior door trim removal

benno said:

Hi guys,
I want to remove the interior door trim to install some speakers and dynamat the doors tomorrow. I had a quick poke around this morning and I think I have the drivers side figured out but I can't figure out the passenger side.

I need to remove some trim around the grab handle to access whatever torx bits are behind it. How do I do this?

And how do I then free up the trim around the door opening handle?

I did search, and there's one DIY thread but the pics no longer work.

Click to expand...

LoyalSage said:

attached you will find two PDFs that explain the removal process of both the driver side and passenger side interior trims.

i hope this helps and answers your questions. goodluck!

Click to expand...

porshah said:

Thanks LoyalSage. I was thinking of doing the same. I have a set of Focal speakers that I pulled from one of my previous cars. Can't wait to put them in the R. Figure while I am at it...I will add some dynamat as well.

Click to expand...

benno said:

Thanks mate, that's awesome!

Got the drivers side mostly done today... I cut the stocko 6.5" driver out and put a hertz split in it's spot. Lots of dynamat... Need to wire in the crossovers and fab up something for the tweeter tomorrow.

And then repeat it all for the passenger side.

So just to clarify - on the passenger side it says "pry upper section of grip shell -1" - does that piece pry out horizontally? Really trying to avoid breaking clips and so on!

Click to expand...

sinair said:

Guys - any way I can get similar instructions to remove the rear door panel?
Siva

Click to expand...